How To Put Lights On A Christmas Tree Correctly

Then put on the next layer of branches and add the lights using the same technique i used on the first layer of branches.

How to put lights on a christmas tree correctly.

A strand of lights is typically made from a few different wires that are braided together into a larger cord. Place some lights deeper into the branches and place some closer to the front to create depth. You can string the lights on a tree from branch wrapping going round and round the tree horizontally to vertically stringing the strands up and down the tree. You should add the christmas lights starting from the bottom back of your christmas tree going toward the trunk of the tree and back out towards the tip of each of the branches.

Try to avoid any obvious pattern or spiral. Hanging lights on a real tree 1 when working with a real tree branches can be less uniform therefore it is best to not wrap the lights around the tree. Start weaving the lights back and forth going down one side of the tree instead wrapping the lights around the circumference of the tree. First put on the bottom layer of branches.

Starting at the bottom string your lights around and through the tree in a random fashion. After each of the lowest branches are covered move the lights up the trunk to the next level of branches and start again until you have reach the very top of your christmas tree. If your branches are attached just fold down the branches layer by layer. Follow the same procedure as for subdued lighting but add dimension to your tree s sparkle by looping the strings a couple of times around on each branch getting some of the lights closer to the trunk.

Today that all cha. Instead weave them around the tree working in triangular sections. Take the first string of lights in your hands and nestle the very last bulb at the top of the tree. There are many ways for putting lights on a christmas tree.

Then wrap each branch going up and down the branch with the lights. To make the lights stick to the tree more permanently pull the wires apart and slip tree branches through the newly created gaps in the strand causing the lights to get a little more stuck in the tree than they would be otherwise. Use six boxes of 100 light strands for a 6 foot christmas tree and eight boxes for an 8 foot tree.