As the first step start by installing the fence posts.
How to install picket fence panels on a slope.
The step method is so named because the fence mimics a set of stairs.
When building a fence on a slope using preassembled panels the entire panel is stepped up or down so it remains level.
You may like my other videos.
This allows the overall line of the fence to follow the slope in a stair step fashion.
This will leave gaps between the bottom of the pickets and the ground.
It gradually steps up or down the slope.
For that dig holes for the posts as you would normally do for the regular fencing proceedings.
Building a fence with preassembled panels.
Smooth lines for gentle curves near west chester pa.
Attach a short block of 2 by 4 to the back of a longer straight 2 by 4.
Let s look at some of the techniques you can use when installing a fence on a slope or a hill.
A spacer will simplify the installation of the remaining pickets.
Install the next picket flush against the spacer to get the proper 3 1 2 inch spacing and to keep the picket plumb.
Just type lsailor1 in the youtube se.
The rack method procedure in which the rails follow the.
Tip typical spacing for wood and metal fences is 8 feet but if you re using the step method on a steep slope you ll probably have to reduce the spacing to avoid.
Use the rack method to install the fence on a gentle slope and install the fence on a slope steeper than 35 degrees using the step method.
When building a fence on uneven terrain one option is to follow the contours of your yard.
Moreover even when the slope is gentle raking creates a fair amount of extra work when installing a chain link fence because you have to cut the ends of the metal mesh at an angle.
Then add concrete to the base of the hole and then put the post in upright position.
The posts are installed plumb and each panel steps lower or higher as the grade changes.
At the end fill up the hole completely with concrete.
A scalloped partial privacy fence installed on a slope by the fence authority.