How To Attach A Wooden Awning To A House

Make sure the hardware you use is tight and that your awning does not wiggle around.

How to attach a wooden awning to a house.

One recommendation is before installing the fasteners drill pilot holes through the cement siding with a high speed drill. Find a good spot. Be sure to follow manufacturer instructions. Attach the brackets to the house even with the chalk line making sure they are plumb.

Attach vertical screens to the extended awning to block the sun when its low in the sky. Dig holes if necessary if you are using an in ground support pole you will want to use a post hole digger. Lag bolts or coarse threaded wood screws are usually specified for the installation but each awning is different. If it is impossible to attach the ledger to a floor joist then fasten the ledger to wall studs which are generally located on 16 inch or sometimes 24 inch centers and doubled up around doors windows and other openings.

You want to make sure that it can be fully extended. Temporarily nail or brace the ledger in place positioned and leveled at the desired height. Awnings need approximately 6 to 12 inches of open heightwise wall or roof space to be installed. Attach mounting brackets to your home and verify they are straight with a level.

Pop a caulk line to mark the position for the support brackets. Make sure that you have an appropriate place for your patio awning. This is a huge benefit of hiring an awning company to create and install your awning. Lift the awning into place and bolt it to the brackets.

They are in essence oversized swatches of water resistant fabric connected to a frame and attached to your house or some other structure. Fasten the awning bar to the brackets. They don t require you to build a permanent structure on the deck. How to attach a patio awning to your house.

Determine what type of material you will want to use for your patio awning. You don t have to take them down no storage hassles. Temporarily affix the fabric to the brackets and use this as a reference to identify exactly where any additional supports will be. They are made out of vinyl canvas or solution dyed acrylic.

Depending on your brand of awning you will use either a large bolt or a screw to attach the awning into the brackets. Attach the hardware through the brackets and over the awning bar to hold it in place. Unless you buy an awning from a retailer which offers a variety of sizes your awning can be any size. Wall space needed for attaching.